Problems Network Configuration

  • Anonymous April 15, 2012 at 7:34 am

    good morning

    I have some trouble configuring my router dir-300 with modified firmware (dd-wrt v.24) as a wifi hotspot for my bar

    The existing network is configured with static ip and then all the guides I’ve consulted with the rationale behind network in dhcp

    I hope someone more practical configuration of networks can help

    thanks

    Anonymous April 15, 2012 at 8:20 am

    Hello,

    you can easily set a static IP instead of DHCP under Setup > Basic Setup in dd-wrt config.

    Anonymous April 15, 2012 at 8:45 am

    If only it were that simple

    Anonymous April 15, 2012 at 8:47 am

    those who connect with dynamic ip can not connect to the internet

    Anonymous April 15, 2012 at 8:55 am

    I have two ADSL connections and several computers connected to a switch.

    everyone has a static ip and each is set a default gateway

    Anonymous April 15, 2012 at 8:59 am

    I wanted to set a subnet with dynamic ip hotspot for setting the dir-300 with a default gateway but can not

    Anonymous April 16, 2012 at 11:23 am

    Hotspot users are handled by chillispot, which is a wireless LAN controller. This process runs on the router and will hand out dynamic ip addresses. These clients will receive an ip address on the 192.168.182.0 network by default but this can be changed, altough you then have to change the login url in the control center also. The default gateway info will be propagated by dhcp, and this can also be set in the router to point to a specific ip address, under basic settings / network setup / gateway.

0 0

You must be logged in to reply to this topic.