Hello,
Yes, please use this firmware for the WRT54GL if you haven’t already done so: http://dd-wrt.com/dd-wrtv2/downloads/others/eko/BrainSlayer-V24-preSP2/2013/07-24-2013-r22118/broadcom/dd-wrt.v24_std_generic.bin
Please use this article to set up the LAN interface: http://www.hotspotsystem.com/hotspot_help/kb/articles/167-configuring-hotspot-interfaces-lan-and-wireless-ports-with-dd-wrt
The Unifi controller could be seen if it’s connected above the WRT54GL (to the main LAN), but this should be configured in the local subnet. You can do this by either setting it in the WRT54GL with adding a host of ‘unifi’ and its IP address or by the following(ssh-ing into the Unifi APs):
# 1. make sure the AP is running the latest (or 2.1.0+)
# if it’s not, do
# syswrapper.sh upgrade http://ip-of-controller:8080/dl/firmware/BZ2/version-of-ap-see-ref-table-below/firmware.bin
# 2. make sure the AP is in factory default state
# if it’s not, do
# syswrapper.sh restore-default
# 3. ssh into the device and type
mca-cli
# the CLI interface:
set-inform http://ip-of-controller:8080/inform
You can see this in http://wiki.ubnt.com/UniFi_FAQ
Best Regards,
Steve Hars,
Hotspotsystem.com