This topic has 9 replies, 3 voices, and was last updated 10 years, 10 months ago by Anonymous.

Ubiquiti router does not automatically go to login page

Anonymous June 1, 2015 at 5:56 pm

I am trying to set up a new Ubiquity router. When I connect to the router, it does not automatically go to the login page (http://192.168.182.1:3990/prelogin). If I manually go to the page, everything works as it should.

Is there something I’m missing?

Marko Molnar June 2, 2015 at 5:37 pm

Hello,

What is the make and model of your router?

What firmware did you upload on the router?

What ip address do you receive when you connect to teh router?

Anonymous June 9, 2015 at 12:00 am

Make/Model: Ubiquiti airRouter HP
Firmware: OpenWrt Barrier Breaker r39207 / LuCI Trunk (svn-r9948) openwrt-ar71xx-generic-ubnt-airrouter-squashfs-factory.bin
IP Address: 192.168.182.2

Marko Molnar June 9, 2015 at 11:12 am

Did you perform all steps from this guide: http://www.hotspotsystem.com/installation-guide-openwrt

Please note that we have an OpenWRT build specifically for that router: http://www.hotspotsystem.com/firmware/openwrt/UBNT/airrouter/

It is much easier to configure the router using our build. Reset the router’s settings and use the following setup guide to configure the router: http://www.hotspotsystem.com/openwrt-hotspot-setup

Anonymous June 11, 2015 at 2:15 am

I used openwrt-ar71xx-generic-ubnt-airrouter-squashfs-factory.bin at that location you linked. I performed all the steps in the guide, but I will reset and do it again.

Anonymous June 11, 2015 at 3:06 am

Why can’t I reply to this thread?

Anonymous June 11, 2015 at 3:15 am

Here’s what’s happening:

I reset the router by entering the following commands:
mount_root
mtd -r erase rootfs_data

The router rebooted, and I logged in and set a password using the web interface at 192.168.1.1

Anonymous June 11, 2015 at 3:16 am

I connected to the router with ssh and logged in. I tried running the commands at the first link you sent, but they did not work, as the router apparently does not have a connection to the internet. It is plugged into the internet via CAT5.

Marko Molnar June 11, 2015 at 1:21 pm

Please check your network. The router needs to have an internet connection when you run the script! What is the router connected to? Can it ping that device? Does it show up on the DHCP leases of that device?

Anonymous November 7, 2015 at 1:43 am

I had problems too with the same router, I used the same firmware updated till this month .

0 0

You must be logged in to reply to this topic.

HotspotSystem Forums

Ubiquiti router does not automatically go to login page